21 Jun ANTRIEBSTECHNIK. Stand 02/ COMBIVERT F4-F. APPLICATION MANUAL. : -K Charge 75,-DM. This manual describes the control of the standard series. COMBIVERT F4-Small. It includes: General installation and connection instructions. Explanation of the. 13 Jun Prima leggere le manuale di istruzione 1 parte! Leer manual de instrucciones parte 1 antes! BETRIEBSANLEITUNG KEB COMBIVERT F4-S.
|Published (Last):||8 November 2014|
|PDF File Size:||13.14 Mb|
|ePub File Size:||11.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page Values set in brackets are valid, when oP. This makes the handling much easier, simplifies the user documentation and improves the safety of operation against unauthorized access see picture 1. However, the drive must not start yet, first the rotation direction reverse has to be selected and confirmed with ENTER point disappears. The correct setting is: The AUX-function offers the possibility to add an analog setpoint to keb f4 manual setpoint settings or to use it as amplification factor for speed controller and torque limits.
Page 56 Parameter CP. Page 94 Average value generation from 4 values updating time 16 ms Average value generation from 8 values updating time 32 ms Average value generation from 16 values updating time 64 ms Chapter Section Page Date Name: The corresponding CP- parameter is not represented at this setting.
For a closed-loop-controlled system it is imperative to ensure the correct correct phase connection, otherwise the controllers keb f4 manual manal into their limit. Got it, keb f4 manual to print. Don’t show me this message again. Page If an adaption to motors with lower voltage V motor on V inverter is c4 out, then the output voltage stabilization may never be switched off. The proportional factor of the position controller is adjusted in CS. keb f4 manual
KEB COMBIVERT F4-F Manuals
Thus keb f4 manual is possible for example to operate 8 different motors on one inverter, that means that the motor dates of each motor are in a separate set. Speed detection channel 2 digital oP. Page In controlled operation this function provides an optimal limit torque characteristic, if the adjusted value corresponds to the inverter input voltage. The parameters for the precontrol profile Pd. Error incremental encoder Missing reference signal zero track at the reference drive, at Pc.
First the setpoint DC-link ,anual is adjusted with Pn. However, the voltage keb f4 manual takes place as adjusted. Page The parameters for the precontrol profile Pd. By meb of the characteristic amplifier the analog signals can be adapted to the requirements.
ID Page LE. Page 2 dr.
Keb COMBIVERT F4-F Manuals
Table Of Contents 3. Page Ink x Pd.
Functional Description Encoder Interface 6. The output is done in parameter ru. In controlled operation this function provides an keb f4 manual limit torque characteristic, if the adjusted value corresponds to the inverter input voltage.
Functional Description Positioning Module Name: At this kb the DC-link control is active. Page 78 A counter-clockwise rotating field reverse is represented by a negative sign see ru. Keb f4 manual C ,00 ,00 0,01 ,00 6. Page In that case the output frequency is put directly on keb f4 manual measured motor speed. Summary Product Description F4-C If this parameter does not exist, then CP.
Page 77 key Page 48 In the field weakening range larger tolerances are possible, also see reference on page 4 M [Nm] CP. Brought in position at reference switch Reference switch cleared, drive X2.
Networks the inverter is fitted with an operator or interface that corresponds to the bus system. Page IBS cycle. But because of the complex application keb f4 manual we must restrict ourselves to explaining the start-up 7.
Starting command for positioning defined di. Summary Product Description 2. In our example from chapter 6. Values set in brackets are valid, when oP.