WCDMA RAN Systems and Site Introduction. RBS components. WCDMA RBS Maintenance. 2. Customer Product Information (CPI) and. TXO Systems has the ERICSSON RBS RRUS 12 B3 in stock, along with a wide range of used and refurbished telecommunications equipment from all. Ericsson shall have no liability for any error or damage of any kind resulting from The support system for the RBS main unit is available in two variants.
|Published (Last):||23 December 2009|
|PDF File Size:||16.45 Mb|
|ePub File Size:||20.43 Mb|
|Price:||Free* [*Free Regsitration Required]|
Make sure that the site power is switched off before starting. Back to home page Return to top.
Make sure that the cable connectors and the connectors on the DU are clean. Detailed information can be found in Site Installation Documentation. Resume making your offerif the page does not update immediately. Remove the protective caps from the connectors on the cables and the DU. There are 3 items available.
Align the connector with the cable protective cap and tie the cable with the cable strap as show in numbers 1 and 2 in the following figure. Learn more – opens in a new window or tab. Fill in the verification checklist in Site Installation Documentation.
Handle the optical cables with care and do not exceed the minimum bending radius the fiber bending radius shall ericssoh be less than 30 mm. Carefully observe the polarity of the cable 660. Interest will be charged to your account from the purchase date if the balance is not paid in full within 6 months. Damage to components mounted on printed board assemblies can occur if an ESD wrist strap is not used.
The following figure shows how to connect the V DC power cable for support system variant 1: To unpack and check the materials, do the following: The instructions in this document describe the installation of the following hardware: The alarm ports are marked on the support erjcsson front panel. Products not connected to ground risk being damaged by overvoltage or overcurrent.
Add to watch list Remove from watch list. See other items More A Prolonged screwdriver is needed to reach the screws. Contact the seller – opens in a new window or tab and request a shipping method to your location.
Ericsson RBS 6601 LTE Indoor Main Unit Remote Base Station 1/bfl 901 009/4
Make sure that cables with recommended cross sectional area are used. The main unit must be unpacked from its transport package in an environment identical to its operating environment. Slot 2 is the upper position in the main unit. Insert the power cable wires into fricsson dedicated tension clamp connection and check that they are properly fastened.
The support system for the RBS main unit is available in two variants: The fans in both support systems are controlled by the primary DU. See all electronauts has no other items for sale.
Ericsson RBS LTE Indoor Main Unit Remote Base Station 1/bfl /4 | eBay
Remove the protective caps from the connector on the cable and the DU. Other documents containing installation instructions are: The cables are optical and must be handled with care.
See Figure 5, letter B. Clean the site and remove objects such as wrapping paper and cable clippings. Optical indicators show rgs board status.
ericsson rbs 6601
Detailed information about optical 660 can be found in Indicators, Buttons, and Switches. Reinsert and tighten the hexagon screw to a torque of 15 Nm using a torque wrench and a 13 mm socket. Place the main unit in the rack and tighten the rack screws on the brackets according to the rack supplier’s specification.
Therefore, install the main unit at a convenient working height and route all cables with necessary extra length to allow the removal of the main unit without disconnecting the cables. The cable connecting the two support systems is 1 m long to allow the removal of the support systems from the rack for service purposes without disconnecting the cables.
Always connect products to ground according to instructions.