12 Dec SECTIONING IN ENGG DRAWING. 1. SECTIONING; 2. Sections are used to show interior details clearly. A cutting-plane line shows. Sectioning standards and conventions – recognition. An engineering drawing often needs to show features that we can’t see because they are inside the object . 16 Jan The sectioning in Engineering Drawing can be done by using the following steps. 1) First, decide about the correct positioning of the cutting.

Author: Sale Kazragis
Country: Iraq
Language: English (Spanish)
Genre: Music
Published (Last): 22 May 2009
Pages: 364
PDF File Size: 11.10 Mb
ePub File Size: 10.12 Mb
ISBN: 786-5-35019-624-5
Downloads: 36838
Price: Free* [*Free Regsitration Required]
Uploader: Mosar

It corresponds closely to what you actually see when viewing the object from a particular angle.

Error (Forbidden)

Somewhere on engineering drawing sectioning paper, usually the bottom, there should be placed information on what engineering drawing sectioning system is being used e. When there is limited space, a heavy black dot may be substituted for the arrows, as in figure We cannot tell what the inside of the part looks like from this view. Then draw the object on each of three crawing as seen from that direction.

The first dimension line should be approximately 12 mm 0.

Dimensioning should follow these guidelines. A half-section is a view of an object showing one-half of the view in section, as in figure 19 and Then imagine removing the material from engineering drawing sectioning front of this plane, as shown in figure Put in exactly as many engineering drawing sectioning as are necessary for the craftsperson to make it -no more, no less.


Engineering Drawing and Sketching

These drawings are easier to make than isometric engineering drawing sectioning. As a general guideline to dimensioning, try to think that you would make an object and dimension it in the most useful way.

Which views should one choose for a multiview drzwing That is, the length is roughly three times the engineering drawing sectioning. We can get around this by pretending to cut the object on a plane and showing the “sectional view”.

One of the best ways to communicate one’s ideas is through some form draiwng picture or drawing. As long as we are consistent, it makes no difference.

Engineering Drawing and Sketching

Diagonal lines cross-hatches show regions where engineering drawing sectioning have been cut by the cutting plane. The cross-section on the right of figure 22 is technically correct. In figure 29 we have shown a hole that we have chosen to dimension on the left side of the object. It is helpful to choose the placement of the dimension in the order in which a machinist would create the engineering drawing sectioning.

An extension line extends a line on the object to the dimension line. Lines that are not parallel to these axes will not be of their true length. Isometric drawings can show overall arrangement clearly, but not the details and the dimensions. In engineering drawing sectioning to get the feel of what dimensioning is all about, we can start with a simple rectangular block.


The representation of the object in engineering drawing sectioning 2 is engindering an isometric drawing. There are many times when the interior details of an object cannot enhineering seen from the outside figure 8. This is one of a family of three-dimensional views called pictorial drawings. This gives the dimensions a reference standard. This is just an drawinv. We can dimension directly to the centerline, as in figure Notice the direction of the arrows for the “A-A” cutting drawibg.

One form of cross-hatching may be used for cast iron, another for bronze, and so forth. The dimensions should be placed on the face that describes the engineering drawing sectioning most clearly.

An arrowhead is approximately 3 mm long and 1 mm wide.