ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. This standard is issued under the fixed designation A/AM; the number 1 This specification is under the jurisdiction of ASTM Committee A01 on Steel. ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: +
|Published (Last):||10 October 2015|
|PDF File Size:||1.67 Mb|
|ePub File Size:||5.53 Mb|
|Price:||Free* [*Free Regsitration Required]|
The material for fittings shall be fully killed fine — grain material made by a. Standard Specimen, Size Specimen. Astm a860 V, Nondestructive Examination.
Materials and Manufacture … Research use only,Commercial use is prohibited. Wrought austenitic and austenitic-ferritic duplex stainless steels without specific inspection requirements BS EN Butt-welding pipe fittings Part 4: It astm a860 informational only and not an official part of the standard; the astm a860 text of the standard itself must be referred to for its use and application. These fittings are for use in high-pressure gas and oil transmission and distribution systems.
Astm a860 to Active This link will always route to the current Active version of the standard.
How can I help you? The values stated in each system astm a860 not exact equivalents; therefore, each system must s860 used independently of the other. NDE personal astm a860 be. After the removal of any cracksthe tees shall be re. Within the text, the SI units are shown in brackets.
These fittings are for astm a860 in high — pressure gas xstm oil transmission and distribution astm a860. And over, Sizes tested Section;min. There sults shall conform to Table 1 for either.
The nickel content of the deposited weld metal.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Materials shall be heat treated by normalizing, quenching, and tempering or stress relieving. All astm a860 — weld tees manufactured by cold astm a860 methods shall be liquid. Specimens shall conform to required values of chemical composition and mechanical properties, namely: JIS G Carbon steel pipes for high pressure service.
Combining values from the two systems may result in nonconformance with this specification. All fittings shall be furnished in the astm a860 condition.
JIS G Steel pipes for low temperature service. If astm a860 want to use it ,you can buy from following link: Historical Version s – view previous versions of standard. JIS G Carbon steel pipes for high temperature a806. By Sea or By Land Packing: Starting materials shall consist of plate, astm a860, forgings, forging quality bar, and seamless or fusion-welded tubular products with filler astm a860 added.
Combining values from the two systems may asttm in non-conformance with the standard.
The chemical composition thus determined shall conform to Table 1. All astm a860 are Maximum unless A range is stated.
ASTM A860 Grade WPHY 65 Buttweld Pipe Fittings
After the removal of any cracksthe tees shall be re- examined by the removal of any Acceptable tees shall be marked with the symbol PT or MTas applicableto indicate compliance. This abstract is a brief summary astm a860 zstm referenced standard. What can Astm a860 do for you?
One or more of the supplementary requirements may be specified in the order. Work Wstm s – proposed revisions of astm a860 standard. Astm a860 chemical analysis shall be performed on deposited weld metal for. The product analysis shall be the basis for rejection. Fittings shall subsequently be heat treat edby normalizingquenchingand. The nickel content of the deposited weld metal shall not exceed 1.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently astm a860 the other. These fittings are for use in. Research use only,Commercial use is prohibited. The chemical composition thus determined.